Procedures for Decontamination of Plutonium From Various Surfaces, Skin

Christensen, E. L, U.S. Atomic Energy Commission, and Los Alamos Scientific Laboratory. Procedures for Decontamination of Plutonium From Various Surfaces. Los Alamos, N.M.: Los Alamos Scientific Laboratory of the University of California, 1959. pp 19-21

See Also: USNRDL-TR-256 PROTECTING AND CLEANING HANDS CONTAMINATED BY SYNTHETIC FALLOUT UNDER FIELD CONDITIONS

Aluminum, Brass, Concrete, Glass, Iron and Mild Steel, Lucite, Plexiglass and Other Acrylic Plastics, Monel, Paint, Plastics Other Than Acryiic Based Plastics, Porcelain, Rubber, Skin, Stainless Steel and Tile.

SKIN

Immediate use of a synthetic detergent-sequestrant mixture has been reported to give better decontamination than if the use of the mixture is preceded by soap and water wash. However, no temperature was given for the water used and if the water was warm enough to cause the pores to open, the decontamination solution, normally used cold, would have a difficult time removing the activity. At Los Alamos steps

19

one and two of the recommended procedure normally give sufficient decontamination.

For decontamination of hair, omit the KMnO4 treatment.

A. Recommended procedure.

1. Lather with liquid soap, using cold water, rinse thoroughly.
2. If count still remains, wash with synthetic detergent and sequestrant in a ratio of 1:2. Rinse with water.

a. Sequestrants such as:

  1. Na EDTA-
  2. Citric acid
  3. Sodium citrate
  4. Sodium tartrate
  5. Sodium phosphates
    1. b. Do not use oxalates!

C.P. Cleaner, manufactured by Finley Products, Inc., is also satisfactory. Apply as label directs.

3. If count still remains, scrub with KMnO4 crystals wet with just enough water to make thick paste. Rinse thoroughly. Repeat 5 times. Remove color with a 4% NaHSO3 solution. (Use only as a last resort.)

4. Apply TiO2 paste and rub thoroughly. Remove by swabbing. Rinse thoroughly with water.

B. Decontamination solutions in order of decreasing effectiveness.

1. TiO2 paste (expensive)
2. KMnO4 paste; color removed with 4% NaHSO3

20

3. Synthetic detergent – sequestrant
4. C.P. Cleaner or similar hand cleaner
5. 3% trisodium nitrolotriacetate – synthetic detergent
6. 3% Na citrate, ph 7.0
7. 3% Na acetate, ph 2.0
8. 3% Na tartrate, ph 7.0
9. 3% Na lactate, ph 7.0
10. 3% glycine
11. 3% Na acetate, ph 7.0
12. Water with liquid soap
13. Isotonic saline solution

Camp Parks, Dublin CA – Cobalt 60 Experiments

Camp Parks which is located next to Dublin California is where the US Navy built a railway track to move a device using Cobalt 60 to irradiate Phantom Sheep. This is part of a series of articles where I will demonstrate the use of radiation at various locations in the San Francisco Area to inform the public of just what they were and still are being exposed to on a daily basis.

Google map of the base

Camp Parks is currently under development for housing projects and the The Federal Correctional Institution, Dublin was built directly on top of various radioactive sites. Continue reading “Camp Parks, Dublin CA – Cobalt 60 Experiments”